OE 9202575
CADILLAC
Lambda sonda
CADILLAC | 9202575 |
Číslo OE, nebo také OE kód či OEM kód - znamená číslo originálního vybavení (Original Equipment) - tedy číslo kompletních součástí nebo podskupin, které byly původně namontovány na vozidlo. OE číslo je zaměnitelné s termínem Originální číslo.
Náhradní díly kompatibilní s OE čísly
-
VEMO Lambda sonda Original VEMO Quality VEM V40-76-0006
zvětšit1 299,-ve skladuProvedení izolace vedení: s izolací ze silikonem potaženého vláknitého pletivaDélka [mm]: 800Počet vedení: 4Lamdasonda: Závit, předběžně namazanýEAN:040460013061054046001306105FIAT5520501855210300LANCIA5520501855210300OPEL05556665008 55 356 (0855356)0855422092025750920257609202577093185456093185493555666488 55 356 (855356)85542292 02 575 (9202575)93185456SAAB920257593185456SUBARU9202575VAUXHALL09195606092025758553569202575CHEVROLET5520501855566648555666509202575GENERAL MOTORS092025755521030055566648920257593185456MASERATI55210300HOLDEN0919560609199591CADILLAC9202575SATURN93191307Konkurenční kódySkladem ve skladu
Doručení na adresu:
- zboží bude doručeno do 2-6 dnů;
- předpokládané datum doručení ve čtvrtek 23. 10. 2025.
Osobní odběr:
- zboží bude připraveno ve středu 22. 10. 2025 odpoledne
v prodejně:
Autokšeft, s.r.o.
V. Hálka 39
543 01 Vrchlabí; - osobní odběr ve skladu není možný.
Pozn. Přesný termín doručení, případně termín možnosti vyzvednutí bude potvrzen po objednání. Dnem se rozumí pracovní den.
Všeobecné informace: Products supplied by us are without exception intended for the designated use. Please note that our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist personnel. There is no guarantee for inappropriate, improper or unintended use. In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.