OE PB20317
ROLLS-ROYCE
Lambda sonda
ROLLS-ROYCE | PB20317 |
Číslo OE, nebo také OE kód či OEM kód - znamená číslo originálního vybavení (Original Equipment) - tedy číslo kompletních součástí nebo podskupin, které byly původně namontovány na vozidlo. OE číslo je zaměnitelné s termínem Originální číslo.
Náhradní díly kompatibilní s OE čísly
-
VEMO Lambda sonda Original VEMO Quality VEM V20-76-0026
zvětšit1 249,-ve skladuProvedení izolace vedení: s izolací ze silikonem potaženého vláknitého pletivaVelikost závitu: M18 x 1,5Tvar zásuvky: kulatýPočet vodičů: 4Délka [mm]: 300Počet vedení: 4Hmotnost [kg]: 0,12294Lamdasonda: Závit, předběžně namazanýEAN:040460013275064046001327506BMW11 78 1 247 407 (11781247407)12474070512474071247406117817420537 513 962 (7513962)1178124740711 78 7 513 962 (11787513962)11 78 1 742 053 (11781742053)11 78 1 742 050 (11781742050)11 78 1 742 049 (11781742049)11 78 1 433 075 (11781433075)1 742 050 (1742050)1 742 049 (1742049)1 433 075 (1433075)1 247 407 (1247407)1 247 406 (1247406)ROLLS-ROYCEPB20364PAPB20364PB20317ALPINA11781742050STANDARD AUTOMOBILESG1108SG1705Konkurenční kódySkladem ve skladu
Doručení na adresu:
- zboží bude doručeno do 2-6 dnů;
- předpokládané datum doručení v úterý 22. 7. 2025.
Osobní odběr:
- zboží bude připraveno v pondělí 21. 7. 2025 odpoledne
v prodejně:
Autokšeft, s.r.o.
V. Hálka 39
543 01 Vrchlabí; - osobní odběr ve skladu není možný.
Pozn. Přesný termín doručení, případně termín možnosti vyzvednutí bude potvrzen po objednání. Dnem se rozumí pracovní den.
Všeobecné informace: Products supplied by us are without exception intended for the designated use. Please note that our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist personnel. There is no guarantee for inappropriate, improper or unintended use. In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.